Infinix X662B Clone Firmware For mobile hang logo or dead phone recover, file 100% tested you can use with any flashing tool like infinity cm2, avenger dongle, miracle box, nck dongle, just open MTK exe or select tab & bootloader then select scatter file and flash your Infinix X662B. must take back your phone firmware and make an EMMC test before flashing.
Requirements Before Flashing (Infinix X662B Flash File)
You will need the following pre-conditions before flashing the firmware with the flash file on Infinix X662B.
A computer with Internet
Download and install MTK USB Mobile driver
Infinix X662B Flash File (Download from HERE).
Infinity CM2 Flashing Software (Available HERE)
How to Flash Infinix X662B Firmware
Install the USB Mobile Drivers that you have downloaded above
Extract the Firmware Flash File on a specific location into your PC
Open supported box setup / Dongle
Complete the correct selection of Mobile CPU type
Load the Flash file
Switch off the Infinix X662B by long-pressing the red button and remove the battery
Plugin the USB to the Charging port of Infinix X662B and another end with the PC and insert the battery again
Pre and hold Boot Key (Vol- & Vol+)
Click on the Flash button on the flashing software screen and wait until the complete process
Disconnect the mobile from the data cable and switch ON the phone
The flashing process is tested only on Infinix X662b. You will get positive results by following the steps and completing the requirements. We are not responsible for any damage or mishap that may occur depending upon the situation at your end.
Make backup all of your personal data such as pictures, videos, contacts, messages, and other important files.
Always make a backup of your mobile before Flashing File