TA-1030_IMAGE_eMP_059Z014_care_50.00.11_001
In this article, you’ll get the firmware flash file Nokia 3310. You can easily tackle the Nokia 3310 firmware issues by following the simple step-by-step instructions.
Requirements Before Flashing (Nokia 3310 TA-1030 Flash File)
You will need the following pre-conditions before flashing the firmware with the flash file on Nokia 3310.
- A computer with Internet
- Download and install the Nokia MTK USB Mobile driver
- Nokia 3310 Care Flash File (Download from HERE).
- Easy-Box Donlge (Available HERE)
- Password techcenteral.com
How to Flash Nokia 3310 Care Firmware
- Install the USB Mobile Drivers that you have downloaded above
- Extract the Nokia 3310 Firmware Flash File on a specific location into your PC
- Open supported box setup / Dongle
- Complete the correct selection of Mobile CPU type
- Load the Flash file
- Switch off the Nokia 3310 by long-pressing the red button and removing the battery
- Plugin the USB to the Charging port of the Nokia 3310 and another end with the PC and insert the battery again
- No boot key just power off and insert the USB cable
- Click on the Flash button on the flashing software screen and wait until the complete process
- Disconnect the mobile from the data cable and switch ON the phone
Flashing Logs
Receiving phone info
Reconnect battery and connect cable to the phone. The battery should be charged
Phone found
Chipset: 0x6260
Hw subcode: 0x8000
Firmware: RETRO.11.02.11.p1
Secure Chip: Yes
Auth File Required: Yes
Sla Challenge pass required: Yes
Factory firmware flashing not supported
Product Code: 059Z014
IMEI: 357300-08-561536-0
IMEI 2: 357300-08-561537-8
FAT: Addr 0xcd0000 Length 0x324000
Sending loader
Chipset: 0x6260 hw_ver: 0xcb00 fw_ver: 0x0
Chip name: MT6260_S0000
Firmware RETRO.11.02.11.p1
NorFlash: [WINBOND] W25Q128FW
Nor Size: 16.00 Mb
Disconnect the phone, replug battery and switch on the phone
Phone disconnected
Info received
File: TA-1030_IMAGE_eMP_059Z014_care_50.00.11_001.sbf
Care Firmware File
File Product Code: 059Z014
File firmware version: 50.00.11
File region: MEA
File country code: PK
File language pack: IJ
File compilled: 2019-11-15 08:40:55
Flashing firmware from F:/E/NOKIA/TA-1030/EasyBox/TA-1030_IMAGE_eMP_059Z014_care_50.00.11_001.sbf
Reconnect battery and connect cable to the phone. The battery should be charged
Phone found
Chipset: 0x6260
Hw subcode: 0x8000
Firmware: RETRO.11.02.11.p1
Secure Chip: Yes
Auth File Required: Yes
Sla Challenge pass required: Yes
Factory firmware flashing not supported
Product Code: 059Z014
IMEI: 357300-08-561536-0
IMEI 2: 357300-08-561537-8
FAT: Addr 0xcd0000 Length 0x324000
Dumping sds partition …
Sending loader
NorFlash: ID [WINBOND] W25Q128FW size 16.00 Mb
Chipset: MT6260_S0000
Sds partition backuped to Backups\TA1030_sds_059Z014_357300085615378_2022-2-5_20-8-56.sbf
Erasing memory blocks
Erasing block 1…
Erasing block 2…
Erasing block 3…
Erasing block 4…
Erasing block 5…
Erasing maui info
Write Data
Writing partition 1…
Writing partition 2…
Writing partition 3…
Writing partition 4…
Writing partition 5…
Disconnect the phone, replug battery and switch on the phone
Phone disconnected
Flashing firmware success (02:24)
Disclaimer
The flashing process is tested only on Nokia 3310. You will get positive results by following the steps and completing the requirements. We are not responsible for any damage or mishap that may occur depending upon the situation at your end.
Make a backup of all of your personal data such as pictures, videos, contacts, messages, and other important files.
