Requirements Before Flashing (Spice S5310 SPD SC6531 Flash File)
You will need the following pre-conditions before flashing the firmware with the flash file on Spice S5310 SPD SC6531.
A computer with Internet
Download and install SPD USB Mobile driver
Spice S5310 SC6531E Flash File (Download from HERE).
Infinity CM2 Flashing Software (Available HERE)
File Password: techcenteral.com
How to Flash Calme Spice S5310 SC6531E Firmware
Install the USB Mobile Drivers that you have downloaded above
Extract the Spice S5310 Firmware Flash File on a specific location into your PC
Open supported box setup / Dongle
Complete the correct selection of Mobile CPU type
Load the Flash file
Switch off the Spice S5310 SC6531E. by long-pressing the red button and removing the battery
Plugin the USB to the Charging port of Spice S5310 SC6531E. and another end with the PC and insert the battery again
Press and hold the Mobile Boot Key (Menu button)
Click on the Flash button on the flashing software screen and wait until the complete process
Disconnect the mobile from the data cable and switch ON the phone
INFO
Platform Version: MOCOR_12C.W13.04.23.BTDialer.13_Release
Project Version: SC6531_BAR
MMI Version: SC6531_BAR
HW Version: SC6531_BAR
Mobile brand:- SPICE
Model number:- S5310
CPU type:- SPD6531E
Note: Always make a backup of your mobile before Flashing File
Disclaimer
The flashing process is tested only on Spice S5310 SC6531E. You will get positive results by following the steps and completing the requirements. We are not responsible for any damage or mishap that may occur depending upon the situation at your end.
Make backup all of your personal data such as pictures, videos, contacts, messages, and other important files.