Tecno_B1P_MT6580_V158_190323
TECNO POP 2 POWER B1P Clone Firmware For mobile hang logo or dead phone recover, file 100% tested you can use with any flashing tool like infinity cm2, avenger dongle, miracle box, nck dongle, just open MTK exe or select tab & bootloader then select scatter file and flash your Tecno B1P. must take back your phone firmware and make an EMMC test before flashing.
Requirements Before Flashing (TECNO POP 2 POWER B1P Flash File)
You will need the following pre-conditions before flashing the firmware with the flash file on Tecno B1P.
- A computer with Internet
- Download and install MTK USB Mobile driver
- Tecno B1P Flash File (Download from HERE).
- Infinity CM2 Flashing Software (Available HERE)
How to Flash Tecno B1P Firmware
- Install the USB Mobile Drivers that you have downloaded above
- Extract the Firmware Flash File on a specific location into your PC
- Open supported box setup / Dongle
- Complete the correct selection of Mobile CPU type
- Load the Flash file
- Switch off the Tecno B1P by long-pressing the red button and remove the battery
- Plugin the USB to the Charging port of Tecno B1P and another end with the PC and insert the battery again
- Pre and hold Boot Key (Vol- & Vol+)
- Click on the Flash button on the flashing software screen and wait until the complete process
- Disconnect the mobile from the data cable and switch ON the phone
Disclaimer
The flashing process is tested only on Tecno B1P. You will get positive results by following the steps and completing the requirements. We are not responsible for any damage or mishap that may occur depending upon the situation at your end.
Make a backup of all of your personal data such as pictures, videos, contacts, messages, and other important files.
 Always make a backup of your mobile before Flashing the File
