Tecno Pop 2F B1f-F8018I-OGo-210224V138
Tecno Pop 2F Firmware For mobile hang logo or dead phone recover DM Verify, Flash file 100% tested you can use with any flashing tool like infinity cm2, avenger dongle, miracle box, nck dongle, just open MTK exe or select tab & bootloader then select scatter file and flash your Tecno KE5. must take back your phone firmware and make an EMMC test before flashing.
Requirements Before Flashing (Tecno Pop 2F Flash File)
You will need the following pre-conditions before flashing the firmware with the flash file on Tecno Pop 2F.
A computer with Internet
Download and install MTK USB Mobile driver
Tecno Pop 2F Flash File (Download from HERE).
Infinity CM2 Flashing Software (Available HERE)
Password techcenteral.com
How to Flash Tecno Pop 2F Firmware
Install the USB Mobile Drivers that you have downloaded above
Extract the Tecno Pop 2F Firmware Flash File on a specific location into your PC
Open supported box setup / Dongle
Complete the correct selection of Mobile CPU type
Load the Flash file
Switch off the Tecno Tecno Pop 2F by long-pressing the red button and removing the battery
Plugin the USB to the Charging port of Tecno Pop 2F and another end with the PC and insert the battery again
Press and hold the Mobile (Vol- + Vol- )Boot key
Click on the Flash button on the flashing software screen and wait until the complete process
Disconnect the mobile from the data cable and switch ON the phone
Disclaimer
The flashing process is tested only on Tecno Pop 2f. You will get positive results by following the steps and completing the requirements. We are not responsible for any damage or mishap that may occur depending upon the situation at your end.
Make backup all of your personal data such as pictures, videos, contacts, messages, and other important files.
