Wiko Sunny 2 Plus Firmware For mobile hang logo or dead phone recover DM Verify, Flash file 100% tested you can use with any flashing tool like infinity cm2, avenger dongle, miracle box, nck dongle, just open MTK exe or select tab & bootloader then select scatter file and flash your Wiko Sunny 2 Plus. must take back your phone firmware and make an EMMC test before flashing.
Requirements Before Flashing (Wiko Sunny 2 Plus Flash File)
You will need the following pre-conditions before flashing the firmware with the flash file on Wiko Sunny 2 Plus.
A computer with Internet
Download and install MTK USB Mobile driver
Wiko Sunny 2 Plus Flash File (Download from HERE).
Infinity CM2 Flashing Software (Available HERE)
How to Flash Wiko Sunny 2 Plus Firmware
Install the USB Mobile Drivers that you have downloaded above
Extract the Wiko Sunny 2 Plus Firmware Flash File on a specific location into your PC
Open supported box setup / Dongle
Complete the correct selection of Mobile CPU type
Load the Flash file
Switch off the Wiko Sunny 2 Plus by long-pressing the red button and removing the battery
Plugin the USB to the Charging port of Wiko Sunny 2 Plus and another end with the PC and insert the battery again
Press and hold the Mobile (Vol- + Vol- )Boot key
Click on the Flash button on the flashing software screen and wait until the complete process
Disconnect the mobile from the data cable and switch ON the phone
The flashing process is tested only on Wiko Sunny 2 Plus. You will get positive results by following the steps and completing the requirements. We are not responsible for any damage or mishap that may occur depending upon the situation at your end.
Make backup all of your personal data such as pictures, videos, contacts, messages, and other important files.